Crown XLS2500
Drivecore Power Amplifier
Visit the Crown store.
SKU: DJK17440 • EAN: 05021196658788
Special Offers When bought with this product
Product Description
Crown XLS2500 Crown's XLS Series amplifiers define the standard for portable PA systems with unmatched performance, technology and affordability.
Its advantageous flexibility includes multiple inputs so you can plug in anything and play anywhere, along with several system setup configurations. The integrated crossovers and switch-mode power supply produce superior sound, and Peakx limiters protect your speakers. Weighing less than 12 pounds, compared to 40 pounds for its competitors, it's much easier to set up and move from show to show.
Bundles
Technical Specs
Stereo, 2 ohms (per ch.): 1550 watts
Stereo, 4 ohms (per ch.): 775 watts
Stereo, 8 ohms (per ch.): 440 watts
Bridge-Mono, 8 ohms: 1550 watts
Bridge-Mono, 4 ohms: 2400 watts
Sensitivity (for full rated power at 4 ohms): 1.4 Vrms
Frequency Response (at 1 watt, 20 Hz - 20 kHz): +0 dB, –1 dB
Signal-to-Noise Ratio: Rated as dBr to full rated 8Ù power output (A-Weighted): > 103 dB
Damping Factor (8 ohm): 10 Hz to 400 Hz: > 200
Crosstalk (below rated 8Ù power): At 1kHz: > 85dB; At 20kHz: >55dB
Input Impedance (nominal): 20 kohms balanced, 10 kohms unbalanced
Load Impedance: 2 to 8 ohms per channel in Stereo; 4 to 8 ohms in Bridge Mono
Ventilation: Flow-through ventilation from front to back
Cooling: Internal heat sinks with forced-air cooling for rapid, uniform heat dissipation
Integrated Processing: PureBand™ Crossover System
Crossover Filter: Linkwitz-Riley 24dB per Octave
Crossover Frequency Range: 50 HZ - 3 kHz
Crossover Mode: Crossover (CH1=LPF, CH2=HPF), LowPass (both channels LPF), HighPass (both channels HPF), Bridge (LPF or HPF).
Peakx™ limiters: Channel independent clip limiter designed to provide maximum output while protecting your loudspeakers
Input Connectors: XLR (one per channel), 1/4-Inch (one per channel), and RCA (one per channel). 1/4-Inch connectors can be used as loop-thrus to distribute signal to additional amplifiers.
Output Connectors: Two 4-Pole Speakon® Output Connectors accept 2-pole or 4-pole Speakon® connectors. The top Speakon connector is wired for both channels so it can be used for bridgemono wiring or for stereo wiring of two speakers to a single Speakon connector. One pair of back-panel binding posts per channel; accepts banana plugs or bare wire. (European models do not accept
banana plugs.)
Dimensions: 10.7-inch (27.2-cm) depth.
Net Weight: 10.75 lb (4.9kg),
Videos
There are no videos for this product.
