HomeDJ MixersAllen & Heath PA12-CP Powered Mixer

Allen & Heath PA12-CP Powered Mixer

Visit the Allen & Heath store.

Discontinued
This product has now been discontinued
Special Offers Added:

SKU: DJK00318

Allen & Heath PA12-CP Powered Mixer Special Offers When bought with this product

Allen & Heath PA12-CP Powered Mixer Product Description

PA series mixers are designed to provide all the tools you need to run a regular stereo PA system in a straightforward ‘walk up and go’ format. You’ll quickly feel at home with these desks, but you’ll also find that Allen and Heath have included a number of those innovative touches that you only get from designers who have many years of ‘real world’ experience. If you care about quality you’ll also appreciate the build standards that the PA series conforms to, including the same individual vertical circuit boards, nutted pots and solid copper buss interconnection as the acclaimed ML series consoles. As for audio performance, PA series mixers have the wonderfully full, open, natural quality that you’d expect from a professional ALLEN&HEATH desk.

Allen & Heath PA12-CP Powered Mixer Bundles

All
All

Technical Specs

Allen & Heath PA12-CP Powered Mixer Tech Spec:

Mono inputs
8 mono channels with Mic [XLR] & Line [TRS] inputs. Line input overrides the XLR input. Individual +48V phantom power switches are provided. New padless two-stage preamp with smooth gain law. Line input goes to second stage for better matching and performance. Switched 100Hz high pass filter. Insert point. 4 band EQ. 4 aux mixes. Mute with LED. PFL button with LED [functions as peak indicator]. 100mm fader.

4 Band EQ
Shelving LF [60Hz], and HF [12kHz]. Fixed LM [250Hz], and swept HM [300Hz - 6kHz]. The fixed 250Hz control has been carefully selected to provide reduction of ‘muddy’ sounds and enhance ‘warmth’

Dual Stereo Channels
Two stereo channels with two unbalanced stereo inputs on each. One is RCA one is TRS jack. Independent gain controls provide source mixing in the channel strip. The top inputs [RCA] can be switched direct to L&R instead of the channel strip providing extra returns. Two band shelving EQ. 4 aux mixes. Stereo balance, mute with LED, PFL with LED, and 100mm fader as mono channels.

4 Auxiliary Sends
From all channels: 2 pre-fade for foldback mixes - these have 100mm fader masters, mute switch with LED, AFL with LED, and TRS outputs [can be routed internally to output section]. 1 post-fade aux mix for FX - this feeds the internal FX and has a TRS jack output for external FX. 1 post-fade aux mix to TRS jack output is provided for external FX or special feeds.

Mix Outputs
Main stereo mix output has 100mm fader control & mute with LED. TRS jack outputs. Mono sum output with level control with switch for subwoofer mode to TRS jack. Record output [RCA] analogue + SPDIF switchable pre/post fader. Twin 12 segment LED bar meter shows program [or PFL /AFL]. Insert points on TRS jack for external processing. Output EQ and routing to internal amplifiers / external systems is provided.

Output EQ
4 band semi-parametric EQ is provided in the output section, this affects the TRS slave outputs, and the internal constant power amplifiers. This offers more control than graphic equalisers for precise management of speakers, especially foldback / monitors. Source selector allows output EQ section to be used on Left / right, L&R sum / foldback1, or foldback1 / foldback2.

Constant Power Amplifiers
1kW i.e. 2 x 500W RMS peak power professional class AB power amplifiers built in. Unique ALLEN&HEATH design gives full output into 4 OR 8 ohms [rear switch selector]. Output is to locking Speakon™ connectors. Thermal management twin fan system. Full protection - input limiter to prevent clipping, short circuit protection, current limit and DC fault sensing. LED indication of: signal presence, peak warning, speaker protect and temperature. AB amp input TRS break-jacks [normalised to output section / slave out jacks] allow independent use of the power amplifiers if desired. Standby mode switch puts amplifier into protect with speakers isolated.

Digital FX
16 program digital FX processor provides reverbs, delays, chorus and others, inc combined. This FX module takes its feed from the post-fade FX aux on the mono & stereo channels. The output of the FX module is controlled by a 100mm fader with mute & PFL and is routed to the stereo mix and FB1&2 with post fade level controls. At this point, 2 TRS inputs with level control provide a way of combining external FX with the internal unit. Internal FX unit can be switched off to use external only if preferred. A footswitch TRS jack is provided to mute the FX channel. Editing of FX can be done via MIDI using ALLEN&HEATH software editor.

Master Section
Background music BGM mode - plays 2 track input into the main mix post fader, allows user to pull down fader (whilst patching, taking a break, or during walk-in) and leave music playing through the amplifiers / speakers. 2 track input [RCA] with level control to L&R - feeds headphone monitor selector [checking recording]. Twin, 3 colour 12 segment LED meter displays active monitor source. Large LED indicates PFL / AFL active - signal overrides L&R / 2TRK monitor source selection. Standby switch uses relays to disconnect the speakers. 2 track output [RCA] analogue + SPDIF allows direct to digital recording. Switchable pre / post master L&R fader. Mono sum out with level [TRS] - mode switch to provide sub feed with 100Hz low pass filter. Phones out [TRS] with level.

PSU
Solid & reliable internal PSU. 1600W design.

Lamp
4-pin XLR socket

Technical Specifications

0dBu = 0.775 Volts rms 0dBV = 1 Volt rms

Maximum outputlevel
TRS +21dBu into 2k ohm load

Nominal outputlevel
L-R +0dBu into 600ohm max load
Other o/p's +0dBu into 2k ohmmax load

Internal headroom
Mix to o/p +21dB
Channels+21dB

Peak LEDs
5dB before clipping

Noise -measured rms 22Hz to 22kHz
Mic EIN ref 150 ohm source -128dB
L-Rresidual <-89dBu (nothing routed)
L-R mix <-85dBu (channels routed)

Frequency response
20Hz to 30kHz +/- 0.5dB

THD +10dbu, 1kHz
Channel to mix o/p <0.006%

Crosstalk - 1kHz
Ch to ch <-90dB
Chl mute shutoff<-95dB
Ch fader shutoff <-95dB

Power Amp
Outputpower Constant Power switchable
= 2 x 500w RMS into 4 ohm
= 2 x 500wRMS into 8 ohm
Frequency response THD+N <0.02%@1kHz

MainsPower - Internal unit, linear regulated Internally wired to requiredcountry voltage
AC mains input 100V to 240V AC @ 50/60Hz
Powerconsumption 1600W max

Mains fuse rating
100-120V AC use T10A 20mm
220-240V AC use T8A 20mm

Mechanical specs

PA12-CP (desk)
Width - 525 mm (20.6”)
Height - 178 mm (7.0”)
Depth - 539 mm (21.2”)
Weight - 21 kg (46 lbs)

PA12-CP (rack)
Width - 484 mm (19.0”)
Height - 446 mm (17.6”)
Depth - 178 mm (7”)
Weight - 21 kg (46 lbs)

Allen & Heath PA12-CP Powered Mixer Videos

Seen a video for Allen & Heath PA12-CP Powered Mixer? Send us the URL and published videos will receive loyalty points!

There are no videos for this product.

Allen & Heath PA12-CP Powered Mixer Reviews

Do you own the Allen & Heath PA12-CP Powered Mixer? Why not write a review based on your experience with it.

Allen & Heath PA12-CP Powered Mixer Questions

Considering purchasing the Allen & Heath PA12-CP Powered Mixer? Have questions? Ask people who've recently bought one.

Add £50 to your order to qualify for Free Delivery.

×

Sign me up for emails

We'll send you updates on the latest offers and promotional events, inspiration and advice. As well as invites to events.

We treat your personal data with care, view our privacy notice here.

×

Allen & Heath PA12-CP Powered Mixer
×

Delivery And Stock Information

Free next working day delivery on all orders over £50 placed before 3:30pm Monday to Friday.

Orders placed at the weekend or after 3.30pm on Friday will be delivered on the following Tuesday (excluding Bank Holidays).

Larger items / orders e.g large bass speakers or multiple speakers may have to be shipped via a pallet service which may take 1-2 days.

Free next day delivery applies only to the UK mainland for orders over £50. Other locations will be charged as follows:

    • Highlands and Islands 2-3 Days* + £25
    • Northern Ireland 2-3 Days* +£10
    • Deliveries will be made subject to the terms and conditions of the courier company. djkit.com will not be held responsible for late deliveries.

In the event that the items ordered are unavailable for next day delivery, you will be contacted by djkit.com to arrange a suitable delivery date.

"In stock" means that the product displayed is either in stock with ourselves or our suppliers and is available for delivery. Stock levels are subject to change without prior notice.

×

Share with your friends

Like this product on Facebook
×

Embed this products in your website

Paste the code below into your webpage or blog to embed this product in your page.

×

Share product

We treat your personal data with care, view our privacy notice here.

×

Finance Available!

0% Interest Free Finance!
0% Finance on all orders over £280
10% deposit then 12 months payment of £40.09

You can apply for finance to purchase this item. A minimum 10% deposit is required and you can opt for either 12, 24 or 36 monthly payments thereafter 17.9% APR.

Allen & Heath PA12-CP Powered Mixer
from £23.44/month
×

Price Promise

We confidently offer the best prices around on our products, but we're only human so occasionally miss something.
Tell us where and we'll endeavour to lower our price for you. Simply complete this form below.

We treat your personal data with care, view our privacy notice here.