Send DJ Kit your Product Review now!.

• The PGX14 System is Multi-Use and expandable. 3-position input level switch enables the bodypack transmitter input to accommodate microphone, line and Guitar level signals from any source using the supplied WA302 1/4 inch to mini 4-pin guitar cable or the optional WA310 Female XLR to mini 4-pin cable. Any Shure Microphone that has a 4-pin mini connector can be used and powered directly from the bodypack
• The Frequency Agile UHF design provides up to 90 selectable UHF frequencies that operate on an 18MHz UHF bandwidth
• Diversity Reception system uses twin receiver circuits to minimise noise and drop out caused by RF interference
• Hi quality sound with quick and easy setup using infrared remote synchronization of channel and frequency status
• Use 9 systems simultaneousy within the 846 - 865 Mhz range for big events
• PGX4 has XLR and unbalanced 1/4 inch jack audio outputs
• PGX1 includes battery power warning lights - 8 hours battery life from 2 x AA 1.5v alkaline batteries
• Rugged carry case and batteries included

PGX14 System Specifications:

• Working Range: 100m (300 ft.) Note: actual range depends on RF signal absorption, reflection, and interference
• Audio Frequency Response +/� 2 dB: Minimum: 45 Hz, Maximum: 15 kHz (Overall system frequency depends on microphone element.)
• Total Harmonic Distortion (Ref. +/� 33 kHz deviation, 1 kHz tone): 0.5%, typical
• Dynamic Range: 100 dB A-weighted
• Operating Temperature Range: �18 degrees C (0 degrees F) to +50 degrees C (+122 degrees F) Note: battery characteristics may limit this range
• Transmitter Audio Polarity: Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive voltage on pin 2 (with respect to pin 3 of low impedance output) and the tip of the high impedance 1/4-inch output

PGX1/WA302 Specifications:

• The WA302 Instrument cable connects the PGX1 body-pack transmitter to a guitar or other instrument. It is 2.5 foot (.75 m), length with 1/4-inch plug and 4-pin mini connector (TA4F)
• Audio Input Level: -10 dBV maximum at mic gain position, +10 dBV maximum at 0dB gain position, +20 dBV maximum at -10dB gain position
• Gain Adjustment Range: 30 dB
• Input Impedance 1 M Ohm
• RF Transmitter Output: 30 mW maximum (dependent on applicable country regulations)
• Dimensions 108 mm H x 64 mm W x 19 mm D (4.25 x 2.50 x 0.75 in.)
• Weight: 81 grams (3 oz.) without batteries
• Housing: Molded polycarbonate case
• Power Requirements: 2 AA size alkaline or rechargeable batteries
• Battery Life: Around 8 hours (alkaline)

PGX4 Specifications:

• Dimensions: 40 mm H x 181 mm W x 104 mm D (1.6 x 7.125 x 4.1 in.)
• Weight: 327 g (11.5 oz.)
• Housing: ABS
• Audio Output Level (Ref. +/� 33 kHz deviation with 1kHz tone): XLR connector (into 600 Ohm load): �19 dBV, 1/4 inch connector (into 3000 Ohm load): �5 dBV
• Output Impedance: XLR connector: 200 Ohm, 1/4 inch connector: 1kOhm
• XLR output: Impedance balanced, Pin 1: Ground (cable shield), Pin 2: Audio, Pin 3: No Audio
• Sensitivity: �105 dBm for 12 dB SINAD, typical
• Image Rejection: 70 dB, typical
• Power Requirements: 12�18 Vdc at 150 mA, supplied by external power supply

Shure Website Link